Rockwell Automation 7000 PowerFlex HMI Offering with Enhanced Functionality - Manual (Page 52)

50 Rockwell Automation Publication 7000-UM201B-EN-P - June 2013
Chapter 4 Drive Terminal Application
To change the name of an existing group:
1. Select a group from the Group Name column.
2. Press the Group Name column header.
3. Enter the new name in the dialog and press enter.
To add parameters to an existing group:
1. Select a group from the Group Name column.
2. Press the Parameter column header in the right panel (see Assign a
Parameter on page 43 ).
To remove an existing parameter from a group:
1. Select a group from the Group Name column.
2. Select the desired parameter from the right panel.
3. Press the Parameter column header.
4. Press Remove.
To delete a group:
1. Select a group from the Group Name column.
2. Press the Group Name column header.
3. Delete the current name and press enter.
TIP The group assignments are stored locally on the terminal where this
application is running. These defined groups will not be available on any other
terminal, unless that terminal also defines the same groups. The custom group
definitions are stored in a file called customdisplay_k1.xml which is typically
in the ‘base’ directory.