Ethernet port, Dim (drive identity module) socket, Hardware reset button – Rockwell Automation 7000 PowerFlex HMI Offering with Enhanced Functionality User Manual
Page 85: Usb port, Sd card socket
Rockwell Automation Publication 7000-UM201B-EN-P - June 2013
83
Hardware
Appendix A
Ethernet Port
The standard RJ45 connector for Ethernet. The port is configured for 100 Mbps,
Full Duplex. A standard Cat5 Ethernet cable is used for connection.
DIM (Drive Identity Module) Socket
The HMI Interface Board module plugs into the DPM via the existing DIM
socket on the DPM. To accommodate the existing external DIMs, the DIM can
be reinserted into the socket on the PFNI board.
Hardware Reset Button
The reset push button (SW1) on the PFNI board restarts the HMI Interface
Board module. This switch does not cause any direct action to occur within the
drive control. Any communications currently active with the Drive will be
disconnected by pressing this button.
USB Port
The USB port on the HMI Interface Board module will be used to replace the
functionality of the RS232 Data Port on the DPM (not currently available). The
majority of PCs and Laptops no longer support a serial port. For these devices,
the USB port can be used instead. A standard type A-B cable is required.
The functionality of the port can be changed by DIP Switch (SW2), (refer to
DIP Switch Settings on page 81
Windows XP and Windows 7 drivers for the USB Port can be found at the
following website:
SD Card Socket
This socket contains an SD Card used to store the majority of files which are
available via the HMI Interface Board.
The SD Card contains a Write Protect Tab. When the Tab is in the upper
position (tab on the left of the card), the card can be written to. If you want to
protect against any updates to the drive over the network, this tab can be set to
the lower position. The lower position is a write protect position and no contents
on the card can be modified.
IMPORTANT
This card should not normally be removed. Removing the card reduces the
functionality of the HMI Interface Board.
Upper Position
Card is open for writing
Lower Position
Card is write-protected