Rockwell Automation 7000 PowerFlex HMI Offering with Enhanced Functionality - Manual (Page 40)

38 Rockwell Automation Publication 7000-UM201B-EN-P - June 2013
Chapter 4 Drive Terminal Application
Binary Parameter
The dialog used for a binary type of parameter, typical of Figure 33 , shows a
descriptive string for each bit position within the parameter. The ‘A’ column
shows the actual state of the bit. The ‘N’ column shows the new value that has
not yet been applied.
To change the state of a bit:
• Click the ‘N’ check box for the appropriate bit.
Apply and OK applies the changes in the ‘N’ column to the actual
parameter.
To leave the dialog without applying any outstanding changes to the
parameter, click Cancel.
Figure 33 - Edit Binary Parameter
Enum Parameter
An enum parameter shows a descriptive text for each value within the range of
the parameter. The dialog used for an enum parameter is typical of
Figure 34 , and
shows the following attributes about the parameter:
• Parameter Number and Name
• Default Value
• Current Value
TIP To quickly clear all bits, click Reset All.
To set all bits, click Set All.