Enable or disable fault masks – Rockwell Automation 7000 PowerFlex HMI Offering with Enhanced Functionality User Manual
Page 49
Advertising
Rockwell Automation Publication 7000-UM201B-EN-P - June 2013
47
Drive Terminal Application
Chapter 4
Enable or Disable Fault Masks
The drive contains numerous fault masks which enable or disable whether that
particular fault occurs.
The screen typical of
contains two panels. The left shows the faults
which are enabled and the right panel shows the faults which are disabled.
Clicking on the column headers sorts the list by either standard drive ordering or
alphabetically.
To change the status of a particular fault:
1.
Select the fault you wish to enable or disable.
2.
Press the arrow (----> or <----) key to move the fault to the other state.
Figure 44 - Masks Setup
TIP
To move all the masks to the other state, select a fault in the group and press
‘All’.
Advertising