Rockwell Automation 7000 PowerFlex HMI Offering with Enhanced Functionality - Manual (Page 64)

62 Rockwell Automation Publication 7000-UM201B-EN-P - June 2013
Chapter 4 Drive Terminal Application
Control Panel The terminal can control the operation of the drive from a remote location.
These functions mimic those which can be found on the drive door if supplied.
The available functions are:
• Stop
• Start
• Reset
• Reverse
• Reference Setpoint
Indications of the drive status are:
• Ready
• Running
• Faulted
• Warning
• Reverse
• Frequency Reference
The Control Panel is displayed by pressing the Status Bar on the bottom of any
screen and is typical of
Figure 62 .
Figure 62 - Control Panel
The control panel remains open as its own window while other screens are being
used. While the panel is active, the terminal must maintain contact with the
drive, or the drive will be react based on the “NetSrvr FltAct’n (HMI Interface
Board Fault Action) parameter #879.
The Control Panel can be closed when not required without affecting the
operation of the drive. Pressing the Status Bar opens and activates the window.
IMPORTANT The top of the Control Panel shows the Drive Name and the Drive’s IP address.
This is critical information when the PC hardware is running more then one
terminal application to different drives.