Rockwell Automation 1734sc-IE4CH E+H Instruments via HART to PlantPAx User Manual - Manual (Page 141)

Rockwell Automation Publication PROCES-UM002A-EN-P - July 2014 141
iTEMP TMT162 Temperature Transmitter Appendix K
Connect an iTEMP TMT162
Temperature Transmitter Use a 2-wire connection to the HART input module.
1. Open the conduit entry of the device.
2. Feed the leads through the opening in the cable gland or through the
conduit entry.
3. Connect the leads as shown in the figure.
4. Ensure the terminal screws are tight. Re-seal the cable gland or conduit by
screwing the cover back on.
5. In order to avoid connection errors, always take note of the hints given in
the section Connection Check in the operating manual.