Rockwell Automation 1734sc-IE4CH E+H Instruments via HART to PlantPAx User Manual - Manual (Page 29)

Rockwell Automation Publication PROCES-UM002A-EN-P - July 2014 29
Configure the HART Device in RSLogix 5000 Programming Software Chapter 2
This example shows the PV values from the device mapped to the data structure.
Configure a HART Input
Module in a FLEX I/O System In RSLogix 5000 software, you must have a project open with a controller already
configured. Make sure the project path is set to the correct controller.
Use RSWHO Active in RSLogix 5000 software to verify that the controller,
HART input module, and devices are active.
To configure the I/O module, follow these steps within the configuration tree.
This example assumes you have a 1756-ENBT interface and a 1794-AENT
adapter.
1. From the configuration tree, right click the 1794-AENT adapter and
choose New Module.
2. From the list, select the HART input module and click Create.