Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 14)

2-2 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
Table 2.1 – Programming Key Descriptions
Key Mode Function
Program or
Monitor Cycles between program and the three monitor mode screens. If you switch
back to program mode, you are returned to the menu or parameter entry screen
you were in before going to monitor mode.
In fault, alarm, or diagnostics menus, returns you to the screen you were in
before pressing .
Program or
Monitor Cycles through the following menus:
• Fault
• Alarm
• Diagnostics
Through these menus, you can review and clear the fault log, review active
alarms, and display diagnostic information for troubleshooting the drive.
See chapter 7 for more information on faults, alarms, and diagnostics.
Program Provides help for menus or parameters in the selected language.
In the Main Menu, provides information about using the menus. In other menus,
it gives a brief overview of the options available in that menu.
In a parameter entry screen, displays the parameter name, number,
input or output, retentive or non-retentive, and units of measure.
To exit a help screen and return to program mode, press
Monitor Displays the status indicators in the selected language.
Press to return to the monitor mode display.
Program or
Monitor If a fault or alarm message is displayed, clears the message and returns to the
previous screen.
In a fault, alarm, or diagnostics menu, returns to the previous screen.
In a help screen, exits help and returns to the previous screen.
Program In menus, goes to the previous menu.
In parameter entry screens:
• If you have started making a change to a value, restores the original value.
• If you have not made any changes, returns to the menu.
• If you have already pressed to accept the parameter change,
returns to the menu and keeps the new value.
Monitor Goes to program mode from any of the monitor screens.
Program In a menu, selects the option at the cursor.
In a parameter entry screen, allows you to change input parameter values. If a
list is available for the parameter, selects the value at the cursor. When the
parameter value has been changed, saves the new value.