Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 24)

3-4 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
Step 11. Open the hatch labeled COM PORT ACCESS on the front cover of the
GV3000/SE drive. (For Bookshelf drives, you will need to remove the
breakout panel above the RS-232 connector.) Plug the serial cable into the
10-pin serial port connector. Make sure it locks into place.
You can now power up the drive, which will power the OIM. See section 3.2 for more
information on OIM power up.
3.1.4 Replacing the OIM
To replace the OIM:
Step 1. Disconnect power from the drive. This will also remove power to the OIM.
Step 2. Unplug the serial cable from the GV3000/SE drive. You will need to press
down on the locking clip to unplug the cable.
Step 3. Disconnect the OIM ground wire.
Step 4. Disconnect the serial cable from the OIM.
Step 5. Remove the hardware that secures the OIM to the enclosure door
Step 6. If the gasketing needs to be replaced, remove it from the enclosure door.
Replace it with gasketing from the new kit.
Step 7. Connect the new OIM using the appropriate steps in section 3.1.3.
3.2 Powering Up the OIM
The OIM is powered when the drive is powered. During power up, the OIM establishes
communication with the drive and reads drive information from the Regulator board.
The OIM indicators are off and the display goes through the power-up sequence
shown in figure 3.2.
!
ATTENTION: Do not install or remove modification kits with power
applied to the drive. Disconnect and lock out incoming power before
attempting such installation or removal. Failure to observe this
precaution could result in severe bodily injury or loss of life.