Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 90)

GV3000/SE OIM Menu and Parameter Organization B-3
• FLD-WEAKEN START RPM (U.016)
• MOTOR TOP SPEED (U.017)
• AC LINE VOLTAGE (U.018)
• CARRIER FREQ (KHZ) (P.047)
• Fault Functions
• MOTOR OVERLOAD ENABLE (P.040)
• MOTOR OVERLOAD TYPE (P.041)
• FLT AUTO RESET COUNTS (P.043)
• FLT AUTO RESET TIME (P.044)
• FUNCT LOSS RESPONSE (P.026)
• OUTPUT PHASE LOSS EN (P.045)
• ENCODER LOSS ENABLE (P.039)
• LOW BUS FLT AVOID EN (U.023)
• HIGH BUS FLT AVOID EN (U.024)
• STOP/RST KEY DISABLE (P.055)
• AUTO/MAN KEY DISABLE (P.052)
• MAN REF PRESET ENABLE (P.053)
B.1.4 Performance Tuning (Vector)
• Speed Loop Tuning
• SPEED REG PROP GAIN (U.012)
• SPEED REG INT GAIN (U.013)
• CURRENT COMPOUND GAIN (U.026)
• INERTIA COMP GAIN (U.027)
• LOSSES COMP GAIN (U.028)
• Torque Loop Tuning
• TORQUE REG PROP GAIN (U.014)
• TORQUE REG INT GAIN (U.015)
• FLUX REG PROP GAIN (U.019)
• FLUX REG INT GAIN (U.020)
• Outer Control Loop
• OCL FEEDBACK SOURCE (U.040)
• OCL LEAD/LAG SELECT (U.041)
• OCL LEAD/LAG LOW FREQ (U.042)
• OCL LEAD/LAG RATIO (U.043)
• OCL REFERENCE GAIN (U.044)
• OCL PROPORTIONAL GAIN (U.045)