Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide User Manual
Page 35
Advertising
Basics of Programming the Drive Using the OIM
4-5
Step 2. Press
. The Speed Control Menu is displayed, as shown in figure 4.6.
Step 3. Use
to move the cursor until it points to Jog Configure, as shown in
figure 4.7.
Step 4. Press
. The Jog Configure menu is displayed, as shown in figure 4.8.
At this point, you can view or change parameter values. See the following sections for
this information.
Figure 4.6 – Speed Control Menu
Figure 4.7 – Speed Control Menu with Cursor at Jog Configure
Figure 4.8 – Jog Configure Menu
6SHHG&RQWURO
)5(1$%/('
'HILQH6SHHG8QLWV
6SHHG/LPLWV
$FFHO 'HFHO7LPHV
)25:$5'5(9&21),*85(
6SHHG&RQWURO
)5(1$%/('
)25:$5'5(9&21),*85(
'UDZ 7ULP&RQILJXUH
6&859((1$%/(
2))
-RJ&RQILJXUH
Advertising