Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 70)

OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers A-1
A
PPENDIX
A
OIM Parameters Cross-Referenced to
Software I/M Parameters and
Parameter Numbers
The parameter names used on the OIM and the names listed in the software I/M are
slightly different. Table A.1 lists all of the OIM parameter names and the corresponding
software I/M parameter name. It also lists the menu path used to access the parameter
through the OIM. You can access all of the parameters through the All Parameters menu.
Table A.2 lists parameters by parameter number.
The RMI parameters listed here are described in the Remote Meter Interface (RMI)
Board I/M (D2-3341).
Table A.1 – OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers
OIM Parameter Name
Software I/M
Parameter Name Type
Parameter
Number OIM Menu Path
AC LINE VOLTAGE AC Line Volts Input H.021 Application Setup
(V/Hz)
AC LINE VOLTAGE AC Line Volts Input U.018 Application Setup
(Vector)
ACCEL TIME Accel Time 1 (RAMP 1) Input P.001 Speed Control
⇒
Accel
& Decel Times
Quick Start (V/Hz and
Vector)
ACCEL TIME -
SECONDARY Accel Time 2 (RAMP 2) Input P.017 Speed Control
⇒
Accel
& Decel Times
AUTO/MAN KEY
DISABLE* AUTO/MAN Key Disable Input P.052 Application Setup (V/Hz
and Vector)
AVOID FREQ BAND 1 Avoidance Frequency
Band 1 Input H.011 Application Setup
(V/Hz)
⇒
Avoidance Frequencies
AVOID FREQ BAND 2 Avoidance Frequency
Band 2 Input H.013 Application Setup
(V/Hz)
⇒
Avoidance Frequencies
AVOID FREQ BAND 3 Avoidance Frequency
Band 3 Input H.015 Application Setup
(V/Hz)
⇒
Avoidance
Frequencies