Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 31)

Basics of Programming the Drive Using the OIM 4-1
C
HAPTER
4
Basics of Programming the Drive
Using the OIM
To program the drive using the OIM, you change the settings for parameters that affect
your application. This chapter describes how to:
• access the parameters and make changes to them
• restore factory default values for the parameters
• use a password to protect your programming
For parameter descriptions and general information about parameters, see the
software I/M.
Appendix A of this I/M lists the OIM parameter names cross-referenced to the
parameter names used in the software I/M.
Appendix B of this I/M describes the full menu paths for accessing the parameters.
4.1 Accessing OIM Menus and Parameters
OIM menus and parameters are accessed in program mode. To select program mode,
press until the key indicator says PROGRAM.
If you exit from a menu or parameter list using , the last menu or parameter that
was displayed is displayed when you return to program mode. To go to the Main Menu
in this case, press until GV3000 Main Menu is displayed at the top of the
screen.
4.1.1 Accessing the Menus
When you enter program mode for the first time after power up, the Main Menu is
displayed, as shown in figure 4.1. Other menus are accessed from the Main Menu.
!
ATTENTION: Only qualified electrical personnel familiar with the
construction and operation of this equipment and the hazards involved should
install, adjust, operate, and/or service this equipment. Read and understand
this section in its entirety before proceeding. Failure to observe this precaution
could result in severe bodily injury or loss of life.