Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 43)

Using Quick Start to Program the Drive 5-3
5.3 Programming the Drive Using Quick Start
Important: If program protection is enabled, you cannot change Quick Start
parameters. See section 4.2, Using a Password to Protect Programming,
to disable program protection.
To use Quick Start:
Step 1. Make sure the drive is stopped (the Running status indicator is off).
Step 2. Make sure the control source is set to OIM. See section 6.2 for instructions
on changing the control source.
Step 3. Press until its key indicator reads PROGRAM.
Step 4. Select the Quick Start menu from the Main Menu. Press . Quick Start
begins and the first Quick Start parameter is displayed, as shown in figure
5.2.
Step 5. Use the and keys to select V/Hz or Vector regulation. When the
selection is correct, press . (Refer to chapter 4 for the procedure to
change parameter values.)
Step 6. You are now at the next parameter entry screen.
Continue going through the Quick Start parameters, changing the values as
needed. Select to accept the value and move to the next parameter
entry screen.
!
ATTENTION: Only qualified electrical personnel familiar with the
construction and operation of this equipment and the hazards involved
should install, adjust, operate, and/or service this equipment. Read and
understand this chapter in its entirety before proceeding. Failure to
observe this precaution could result in severe bodily injury or loss of life.
ATTENTION: Some of the parameters in Quick Start can cause the
drive to operate improperly if the values are entered incorrectly. Incorrect
values can cause the drive to operate outside of the recommended
operating conditions. Verify that the values of these parameters are
appropriate for your application before changing them. Failure to
observe these precautions could result in bodily injury.
Figure 5.2 – First Quick Start Parameter Entry Screen