Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 36)

4-6 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
4.1.4 Viewing Parameter Values
In the parameter lists, parameter values are shown to the right of the parameter name,
as shown in figure 4.8. After you have looked at the parameter values, press to
return to the previous menu.
Note that read-only (output) parameter values are updated from the drive
approximately two times per second.
4.1.5 Changing Parameter Values
You can change the values of input parameters in the parameter entry screens. (You
cannot change the value of read-only parameters.) Figure 4.9 shows an example of
the parameter entry screen for JOG RAMP ACCEL TIME (P.021).
To exit a parameter entry screen without making any changes, press .
To change a parameter value:
Step 1. Go to the menu that contains the parameter you want to change by using the
procedure in section 4.1.3.
Step 2. Use to move the cursor until it points to the parameter. Press .
Step 3. You will see either:
• the existing value with the cursor blinking at the far right digit, like the
screen shown in figure 4.9.
• a list of options, like the screen shown in figure 4.10
!
ATTENTION: Only qualified electrical personnel familiar with the
construction and operation of this equipment and the hazards involved should
install, adjust, operate, and/or service this equipment. Read and understand
this section in its entirety before proceeding. Failure to observe this precaution
could result in severe bodily injury or loss of life.
Figure 4.9 – Example of a Parameter Entry Screen