Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 84)

OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers A-15
H.006 DC BRAKING START FREQ
H.007 DC BRAKING CURRENT
H.008 DC BRAKING TIME
H.009 AVOID FREQ ENABLE
H.010 AVOID FREQ MIDPOINT 1
H.011 AVOID FREQ BAND 1
H.012 AVOID FREQ MIDPOINT 2
H.013 AVOID FREQ BAND 2
H.014 AVOID FREQ MIDPOINT 3
H.015 AVOID FREQ BAND 3
H.016 SYNC DIRECTION
H.017 INPUT PWR/SNUB CONFIG
H.018 VHZ-CURVE TYPE
H.019 IDENTIFICATION RESULT
H.020 IDENTIFICATION RQST
H.021 AC LINE VOLTAGE
H.022 OVERFREQUENCY LIMIT
U.000 TORQUE REF SOURCE
U.001 ENCODER PPR
U.002 MOTOR POLES
U.003 MOTOR NAMEPL BASE FRQ
U.004 MOTOR NAMEPL AMPS
U.005 MOTOR NAMEPL RPM
U.006 MAGNET CURRENT PRCNT
U.007 MOTOR NAMEPL VOLTS
U.008 TORQUE SELF-TUNE EN
U.009 TORQUE SELF-TUNE RSLT
U.012 SPEED REG PROP GAIN
U.013 SPEED REG INT GAIN
U.014 TORQUE REG PROP GAIN
U.015 TORQUE REG INT GAIN
U.016 FLD-WEAKEN START RPM
U.017 MOTOR TOP SPEED
U.018 AC LINE VOLTAGE
U.019 FLX REG PROP GAIN
U.020 FLX REG INT GAIN
U.021 ROTOR TIME CONSTANT
U.022 MOTOR NAMEPL HP
Table A.2 – OIM Parameters Listed by Parameter Number (Continued)
Parameter Number OIM Parameter Name