Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide User Manual
Page 62
Advertising
Troubleshooting the Drive Using the OIM
7-3
7.2
Reviewing and Resetting Faults Using the Fault Menu
Through the Fault Menu, you can review and reset faults. To access the Fault Menu,
press
. The key indicator displays FAULT and the Fault Menu is displayed, as
shown in figure 7.3.
7.2.1 Reviewing the Fault Log
You can review the fault log to check fault messages and to determine when faults
occurred.
Step 1. Select Review Log from the Fault Menu. The Review Log is displayed. A
sample is shown in figure 7.4.
Log entries start with the most recent fault. If a fault is detected while you are
in the log, the display is updated to show the new entry.
Figure 7.3 – Fault Menu
Figure 7.4 – Example of a Fault Log Screen
Advertising