Bendix Commercial Vehicle Systems VORAD EVT-300 TROUBLESHOOTING - Manual (Page 100)

Fault Isolation Procedures
3-3
Side Sensor Not Detecting Targets
Overview
This symptom driven test is performed when the Bendix ™ VORAD ®
system fails to detect objects properly.
Detection
The VORAD Central Processing Unit has no fault detection
capability for this symptom. The symptom is observed by the driver
when objects at 2-10 feet (0.61-3 m) are not detected. The red light
also illuminates when the side sensor has failed.
Fallback
There is no fallback mode for this symptom. The Side Sensor will
not operate properly.
Required Tools
• PC-based or Hand-held Diagnostic Tool
Possible Causes
This fault can be caused by any of the following:
• Side Sensor
• Faulty Wiring
Harness
Right
Side Sensor
Central
Processing Unit