Electrical pretest – Bendix Commercial Vehicle Systems VORAD EVT-300 TROUBLESHOOTING User Manual
Page 13
Advertising
Fault Isolation Procedures
Electrical Pr
etest
2-2
Electrical Pretest
Step A
Procedure
Condition
Action
1. Key off.
2. Inspect starter/battery
connections for integrity.
3. Measure voltage across
battery.
If voltage is 11 to 13 volts
on a 12 volt system or 22 to
26 on a 24 volt system
If voltage is outside of
range
Go to Step B.
Repair or replace batteries and
charging system as required.
Repeat this step.
VOLT
V
A
COM
Advertising