Bendix Commercial Vehicle Systems VORAD EVT-300 TROUBLESHOOTING - Manual (Page 99)

Symptom Isolation Procedures
Antenna T
arget
Detection T
est
3-2
Antenna Not Detecting Targets
Step A Procedure Condition Action
Step V Procedure Condition Action
1. Align the Antenna using
the Antenna Assembly
Alignment Procedure in
the Bendix
™ VORAD ® system
Service Manual (BW2863).
Note: If fail light is on go to
the appropriate isolation
procedure.
1. Key on.
2. Drive vehicle to
determine whether the
complaint has been
repaired.
Antenna is aligned properly
Antenna can not be aligned
properly
If complaint has been
repaired
If complaint has not been
repaired
Go to Step V.
Replace Antenna.
Go to Step A.
Test complete.
Return to Step A to fi nd error in
testing.