Bendix Commercial Vehicle Systems VORAD EVT-300 TROUBLESHOOTING User Manual
Page 49
Fault Isolation Procedures
Code 15
(SID 10, FMI 2)
2-38
Code 15 (SID 10, FMI 2) Right Side Sensor
Step A
Procedure
Condition
Action
Step B
Procedure
Condition
Action
1. Key off.
2. Is vehicle equipped with a
Right Side Sensor?
1. Key off.
2. Disconnect 3-way stub connector at
the Right Side Sensor.
3. Key on.
4. Measure voltage between:
• Pins A and B.
• Pins A and C.
If the vehicle has a Right Side
Sensor
If the vehicle does not have a
Right Side Sensor
If voltage between pins A
and B is 1.8 to 2.5 volts and
If voltage between pins A
and C is 7.0 to 7.5 volts
If voltage is outside of range
Go to Step B.
The Central Processing Unit
has been programmed for a
Right Side Sensor. With a
PC-based or Hand-held
Diagnostic Tool, place the
Right Side Sensor option in
“NO” position. Go to Step V.
Replace Right Side Sensor.
Go to Step V.
Go to Step C.
VOLT
V
A
COM
VOLT
V
A
COM
B
A
C
B
A
C