Bendix Commercial Vehicle Systems VORAD EVT-300 TROUBLESHOOTING - Manual (Page 65)

Fault Isolation Procedures
Code 22
(SID 8, FMI 2)
2-54
Code 22 (SID 8, FMI 2) Left Turn Signal
Step A Procedure Condition Action
Step B Procedure Condition Action
1. Key off.
2. Is the vehicle equipped
with a Left Side Sensor?
1. Key off.
2. Disconnect the 32-way Central
Processing Unit connector.
3. Key on.
4. Measure voltage between
Central Processing Unit
32-way connector pin D15
and C2.
Note: Do not short pins while
performing measurement.
If equipped with a Left
Side Sensor
If not equipped with a
Left Side Sensor
If voltage is below .5 volts
If voltage is outside of range
Go to Step B.
The Central Processing Unit
has been programmed for a
Left Side Sensor. With a
PC-based or Hand-held
Diagnostic Tool, place the
Left Side Sensor option in
“NO” position. Go to Step V.
Go to Step C.
Repair OEM wiring harness
as required. Go to Step V.
C
VOLT
V A COM
1
D
2
3
4
5
6
7
8
9
10
11
12
13
14
16
15