Metrohm 815 Robotic Soliprep for LC - Manual (Page 12)

2.1 Preparing the Sample Processor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 ￭￭￭￭￭￭￭￭ 815 Robotic Soliprep for LC
2 Installation
It is assumed for the purpose of these installation instructions that the
required adjustment of turntable and Swing Heads has already been per-
formed for the present Robotic Sample Processor.
2.1 Preparing the Sample Processor
Plugging in the mains cable
The mains connector is located on the rear side of the instrument.
Connecting the Swing Heads
Note
The necessary settings must first be made in the (MagIC Net) control soft-
ware before the robotic arms can be mounted on the Swing Heads. The
two Swing Heads are connected for this purpose, but the robotic arms
are not yet mounted.