Metrohm 815 Robotic Soliprep for LC - Manual (Page 27)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 Installation
815 Robotic Soliprep for LC ￭￭￭￭￭￭￭￭ 21
Mount the 6.1462.240 robotic arm to tower 1 as follows:
1 Align the robotic arm parallel to the left-hand edge of the Swing Head
reinforcement and graze it across the guide pins of the drive disc of the
Swing Head from below. The correct position of the arm can be found
in the previous illustration
Note
Take care to ensure that you do not twist the drive disc, thus causing
pressure against the drive.
2 Screw the robotic arm to the Swing Head tightly with the screws and
washers provided.
Mounting the transfer tubing
A sufficiently long transfer tubing is required for aspirating or expelling sam-
ples. The 6.1562.130 transfer tubing contains more than 10 mL of volume
and is placed in a holder on the guide chain of tower 1. Mount it as follows:
6.1562.130
1 Use a screwdriver to open and remove one of the chain links on the
guide chain, see for this purpose (see Chapter 2.11, page 28).
2 Hang the holder with the 6.1562.130 transfer tubing in the guide chain
in place of the removed chain link and press it into place.
Mounting the Luer adapter
Filters or injection needles should be able to be picked up with the transfer
robotic arm. The 6.1808.220 adapter is used for this purpose. Mount it as
follows: