Metrohm 815 Robotic Soliprep for LC - Manual (Page 53)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Setting lift positions
815 Robotic Soliprep for LC ￭￭￭￭￭￭￭￭ 47
6 Under Lift position select the Work position for Special beaker
1.
7 Click on the associated [Assign] button.
8 Click on [Close].
9 Move the lift upward and remove the membrane filter.
Special beaker 2
1 Move to special beaker position 2. Under Rack position, enter Target
position 104 and click [Start].
2 Place a sample beaker on the established position.
3 Move the lift downward until the Luer adapter arrives at a suitable
position for rinsing the transfer tubing. Click on the arrow button
[Arrow down] and also (if required) [Arrow up] under lift position
in order to set a suitable position.
4 Click on [Configure rack].
5 Under Lift position select the Work position for Special beaker
2.
6 Click on the associated [Assign] button.
7 Click on [Close].