Figure 11, Guide chain - opening chain links – Metrohm 864 Robotic Balance Sample Processor User Manual
Page 26
Advertising
3.3 Guide chain for cables and tubing
■■■■■■■■■■■■■■■■■■■■■■
18
■■■■■■■■
864 Robotic Balance Sample Processor
Figure 11
Guide chain - Opening chain links
2 Insert into the guide chain
■
Place the required tubings or cables into the guide chain.
3 Close the guide chain
■
Close the clip for each chain link again by hand and apply forceful
pressure to snap them into place.
Caution
Take care to ensure when mounting tubing and cables that there is no
traction on the drives while moving the lift or swiveling the robotic arm.
This could lead to overloading of and possible damage to the drive.
Remove the clips of the two lowest chain links when you install the
rinsing and aspiration tubing.
Advertising