Metrohm 864 Robotic Balance Sample Processor - Manual (Page 28)

3.5 Configuring instrument components ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
20 ￭￭￭￭￭￭￭￭ 864 Robotic Balance Sample Processor
For Windows Vista: The instrument is recognized and the installa-
tion assistant for the driver is started automatically. Select the option
"Find and install driver software". Agree to all subsequent requests.
The installation assistant will be exited automatically.
Note
The plug on the instrument end of the 6.2151.000 controller cable is
protected with an anti-pull device to prevent the cable from being
pulled out accidentally. If you wish to pull out the plug, then you must
first retract the outer plug sleeve marked with arrows.
Registering and configuring the instrument in the PC soft-
ware
The instrument must be registered in the configuration of your PC soft-
ware. Once that has been done, you can then configure it according to
your requirements. Proceed as follows:
1 Setting up the instrument
￭ Start up the PC software.
The instrument is recognized automatically. The configuration dia-
log for the instrument is displayed.
￭ Make configuration settings for the instrument and its connec-
tors.
More detailed information concerning the configuration of the instu-
ment can be found in the documentation for the respective PC soft-
ware.
3.5 Configuring instrument components
3.5.1 Configuring robotic arms
Before mounting the robotic arms their configuration data must be
entered in the control software.