2 connecting a stirrer or titration stand, Connecting a stirrer or titration stand, Figure 38 – Metrohm 864 Robotic Balance Sample Processor User Manual
Page 69: Connecting a dosing device, Figure 39, Connecting msb stirrer, Figure 38 connecting a dosing device, 1 connect a stirrer or titration stand, Exit the control software, Start the control software
■■■■■■■■■■■■■■■■■■■■■■
3 Installation
864 Robotic Balance Sample Processor
■■■■■■■■
61
USB 1
Contr.
MSB 2
MSB 3
T.2400.102
Figure 38
Connecting a dosing device
3.21.2
Connecting a stirrer or titration stand
You can use a magnetic stirrer 801 Stirrer or 803 Ti Stand (stirring "from
below") or the 804 Ti Stand with a rod stirrer 802 Stirrer (stirring "from
above").
Connect a stirrer or a titration stand as follows:
1 Connect a stirrer or titration stand
■
Exit the control software.
■
Connect the connection cable of the magnetic stirrer or of the
titration stand to one of the sockets marked with MSB on the
rear of the control instrument.
■
If desired, connect the rod stirrer to the stirrer socket (with stirrer
symbol) of the titration stand.
■
Start the control software.
USB 1
Contr.
MSB 2
MSB 3
Figure 39
Connecting MSB stirrer