Metrohm 864 Robotic Balance Sample Processor - Manual (Page 46)

3.13 Installing the balance and the ionizer ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
38 ￭￭￭￭￭￭￭￭ 864 Robotic Balance Sample Processor
units and their solutions. They can also be added to the solution
table and be configured there.
3.13 Installing the balance and the ionizer
Preparing the balance
Various accessory parts are supplied with the balance and are necessary
for the installation.
1
2
1 Mounting the weighing column
￭ Carefully introduce the weighing column into the balance from
above.
2 Fixing the weighing column
￭ Guide the associated fixing ring over the column and screw it
tightly.
Leveling and connecting the balance
The balance must be leveled prior to installation. The cable for the balance
must be connected before the balance is brought into position.
Proceed as follows:
1 Leveling the balance
￭ Rotate the two foot screws of the balance until the air bubble in
the spirit level (on the rear side of the balance) comes to rest in
the inner circle of the spirit level.