Metrohm 864 Robotic Balance Sample Processor - Manual (Page 34)

3.6 Setting up the Swing Heads and robotic arms ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
26 ￭￭￭￭￭￭￭￭ 864 Robotic Balance Sample Processor
3.6.2 Mounting the robotic arms
Mounting the pipetting robotic arm
Mount the bent robotic arm 6.1462.240 on tower 1 as follows:
6.1462.240
1
2
Figure 13 Mounting the bent robotic arm
1 Position the robotic arm
￭ Align the robotic arm parallel to the left-hand edge of the Swing
Head reinforcement and graze it across the guide pins of the drive
disc of the Swing Head from below.
The correct position of the arm can be found in the previous illus-
tration
Note
Take care to ensure that you do not twist the drive disc, thus caus-
ing pressure against the drive.
2 Fix the Swing Head
Screw the robotic arm to the Swing Head tightly with the screws and
washers provided.
Mounting the adapter
Pipetting tips can be taken up with the bent robotic arm. The
6.1808.250 adapter is used for this purpose. Mount it as follows: