3 tutorial, 1 entering data, setting the dialog language – Metrohm 787 KF Titrino User Manual
Page 12
2.3. Tutorial
787 KF Titrino
8
2.3 Tutorial
This short operating course teaches you to work quick and efficient with the 787 KF Ti-
trino, by means of the most important applications.
Set up your Titrino and connect the peripheral devices needed, see chapter 4.
2.3.1 Entering data, setting the dialog language
We can thus make a start and first take a look at the fundamentals of the entry of data.
We change the dialog language.
<CONFIG>
3 × <CONFIG>
<ENTER>
<SELECT>
<ENTER>
• Switch on the Titrino. It is now in the standby state, it
shows you the active mode.
• Press the key <CONFIG>, the display shows:
This is the title of the group "KF device settings".
This group contains various inquiries for the KF titra-
ton.
• Press <CONFIG> 3 times. You see the titles of the
other groups of inquiries in the configuration menu.
The display shows
This "auxiliaries" group contains the inquiry for the
dialog language.
• Pressing the <ENTER> key takes you to the inquir-
ies of the group "auxiliaries". Note the ">" sign. All ti-
tles of inquiry groups are prefixed by this sign.
This is the first inquiry of the "auxiliaries" group: the
selection of the dialog language.
• You select the various dialog languages with the
<SELECT> key. Press <SELECT> repeatedly until
"español" appears in the display.
Note the sign ":". It appears if the values can be se-
lected with the key <SELECT>.
• Accept the new "value" with <ENTER>.
The next inquiry "fecha" (date) of the group "ajustes
varios" (auxiliaries) is shown.
You can open this inquiry by pressing <ENTER>
too and go through all the inquiries of this group this
KFT ********
>KF device settings
KFT ********
>auxilliaries
KFT ********
dialog: english
KFT ********
dialog: español
KFT ********
KFT ********
fecha 2002-03-27