B&G H2000 Pilot *DISCONTINUED* - Manual (Page 122)

HB-0844-04
5-5
5.2.6 Sea Temperature Sensor
Measures the sea water temperature.
5.2.7
Air Temperature Sensor
Measures local air temperature.
5.2.8
Load Cells
Facility is also provided for the input of load cell data. The load cells should
provide an output of 0-6.5 volts.
5.2.9
Sensor Input Configuration
Additional sensors can be added to the system by connecting to one of the
four linear inputs on the Main Processor or the additional inputs on the
Expansion Unit. These can be configured to take different sensors. If you
connect the sensor to the linear input that B&G have anticipated then you
need take no action beyond the connection itself, since the default linear
input configuration will be the right one. The default settings for the four
inputs on the Main Processor are as follows:
Linear 1 = Heel Angle
Linear 2 = Trim Angle
Linear 3 = Barometric Pressure
Linear 4 = 0 to 1000 format
Should you wish to connect one of the other sensors, then you will have to
reconfigure the linear channel that you are connecting it to. This is done by
following the menu path:
MISC
→ → LINEAR X, CALBRATE → → CAL VAL1
The number you enter to CAL VAL1 should correspond to the sensor you
are connecting as follows:
1 = Normal Linear output 0-1000
2 = 152 Wind Speed
3 = Mast Angle Sensor
4 = Heel Angle Sensor
5 = Trim Angle Sensor