B&G H2000 Pilot *DISCONTINUED* - Manual (Page 129)

HB-0844-04
5-12
5.6.3 Function Selection - Remote Push-Button
If a Remote Button is connected to a 20/20 Display any one of the 14 pre-
set functions may be selected by pressing and holding down the associated
Button. The Display will then cycle through the functions. When the required
function is displayed, release the Button.
If the Button is held down too long and the required function is missed, press
and hold down the Button again. The Display will then cycle though the
functions in reverse order. When the required function is displayed, release
the Button.
5.6.4
Function Selection - FFD
An alternative to using a dedicated Remote Push-button, is to control the
20/20 using any one of the standard FFDs on the system. Any 20/20 can be
controlled from any FFD.
To change the function displayed on a 20/20 using a standard FFD, proceed
as follows:
(1) At the FFD, press and hold down the Page Key for at least 3
seconds. The FFD Display will change to show the function
displayed on the 20/20 together with the display number. The
selected Display will start to flash.
(2) Using the Scroll Down Key cycle through the 20/20 numbers
and select the required Display Number.
(3) Using the Scroll Up Key cycle through the 14 pre-set functions
until the required function is displayed on the FFD. Release the
Scroll Up Key.
(4) If the function is missed, press and hold down the Scroll Up
Key and the functions will cycle through in reverse order. Release
the Scroll Up Key when the required function is displayed.
(5) Press the Page Key. The FFD will now return to normal
operation and the 20/20 will display the selected function.