B&G H2000 Pilot *DISCONTINUED* - Manual (Page 74)

HB-0844-04
3-9
3.2.8 Boat Speed Calibration (Knots, MPH, KPH)
To select and calibrate the required boat speed units proceed as follows:
(1) Press Scroll Up until the upper text shows LOG flashing.
(2) Press Enter, the upper text now shows STD LOG flashing.
(3) Press Scroll Up until the upper text shows TRIP LOG flashing.
(4) Press Enter until the upper text shows TRIP LOG and the
current value.
(5) Press Scroll Down until the lower text shows CALBRATE
flashing.
(6) Press Enter, the lower text now shows CAL VAL 1 flashing.
(7) Press Scroll Down repeatedly and the lower text will cycle
through CAL VAL 1, CAL VAL 2, and CAL
VAL 3.
When CAL VAL 1 is displayed:
(8) Press Enter and the lower text shows SPD KTS.
When CAL VAL 2 is displayed:
(9) Press Enter and the lower text shows SPD MPH.
When CAL VAL 3 is displayed:
(10) Press Enter, the lower text shows SPD KPH.
For whichever selection is made:
(11) Press Enter, the lower text now shows SPD KTS, SPD MPH,
or SPD KPH with the current boat speed value in its original units.
(12) Press Enter, the current boat speed value, in its original units,
will flash.