B&G H2000 Pilot *DISCONTINUED* - Manual (Page 37)

HB-0844-04
2-18
For example, when the SECTOR alarm is turned on, the alarm reference
heading is the current compass heading. If the SECTOR alarm is set at 40°
the sector value is the compass heading +/- 20°. It is therefore important to
switch OFF the SECTOR alarm before carrying out a course alteration and
switching the alarm on again when settled on the new course heading.
Any alarm can be switched ON and OFF individually, or all alarms can be
switched OFF collectively.
2.7.3
Set LO Alarm - Depth
(1) Select function which requires alarm facility, e.g. DEPTH.
(2) If the selected function is in the upper display, press Scroll
Down and scroll the lower display until ALARMS appears, flashing.
If the selected function is in the lower display use Scroll Up.
(3) Press Enter and the text shows ALL OFF, flashing.
(4) Using Scroll Up or Scroll Down as appropriate, scroll through
until the text shows LO ALARM flashing.
(5) Press Enter and the display shows the current LO ALARM
value.
(6) To change the LO value, press Enter, and the value flashes.
(7) Press Scroll Up or Scroll Down to increase or decrease the
value as required. Press Enter to accept the new value and switch
the alarm ON.
(8) Press Page to return to the normal display.
To select the HI alarm, scroll through the text until HI ALARM appears and
press Enter to reveal current HI ALARM value. To change the value, use the
same procedure as used to change the LO ALARM value.