B&G H2000 Pilot *DISCONTINUED* - Manual (Page 41)

HB-0844-04
2-22
(3) Press Enter again and the original page display appears.
Control of the FFD Lighting is now in local mode.
Successive operation of the Power/Lights Key now controls the illumination
level on that display only. This will enable you to use very low lighting at the
chart table whilst keeping a higher intensity display up on deck.
2.9.2
Select System Control
(1) Press and hold Scroll Up or Scroll Down until LIGHTING is
displayed in the text.
(2) Press Enter and Scroll Up or Scroll Down to select
SYSTEM.
(3) Press Enter again, the original page display appears and the
illumination control has returned to System Control.
Note
In order to control the lighting on analogue repeaters, at least one FFD must
be set to System Control.
2.10
OPERATING NOTES
Within the preceding paragraphs of this part of the manual the steps
necessary to select a specific function and/or setup the system have been
described in detail. The remainder of this manual contains some detailed
examples; therefore to describe further operations the following shorthand
system has been adopted.
Each successive selected menu choice will be in capitals, separated by a
→
symbol. For instance the example in Para 2.5.1, to manually calibrate the log,
would be presented as follows:
SPEED
→
BOAT SPD, CALBRATE
→ → MANL CAL → → SINGLE