B&G H2000 Pilot *DISCONTINUED* - Manual (Page 89)

HB-0844-04
3-24
3.5.3 Heel and Trim angle with the Halcyon Gyro Stabilised Compass.
The heel and trim information from the Halcyon Gyro Stabilised Compass is
displayed in the PERFORM menu.
The H symbol will be placed on left indicating heel to port and on the right for
heel to starboard. The display will always be shown to 1 decimal point
The U symbol on the left indicates that the bow is up, while a d will be shown
indicating bow down. The display will always be shown to 1 decimal point
Both heel and trim have an offset calibration to allow for any constant errors,
adding or subtracting from CAL VAL 1 will correct this.
PERFORM
→
HEEL, CALIBRATE
→ → CAL VAL 1
PERFORM
→
TRIM, CALIBRATE
→ → CAL VAL 1
If you have heel and trim sensors connected to your system as well as a
Halcyon Gyro Stabilised Compass then the Heel and Trim from the
Compass will be used by default. If you wish to use your external sensors
then set CAL VAL 2 to ‘0’.
PERFORM
→
HEEL, CALIBRATE
→ → CAL VAL 2
PERFORM
→
TRIM, CALIBRATE
→ → CAL VAL 2
3.6
TRUE WIND CORRECTION
It is finally time to go sailing and begin the calibration of the True Wind
Speed and Direction. But before we begin the 'how' a short discussion of the
'why' is worthwhile.