Jeppesen FliteDeck 3 - Manual (Page 166)

Enroute Nav Page
169
• Ground Speed
• Average Speed since takeoff
• Trip Time
• Odometer displays distance traveled over the ground.
• Time Off displays the local and Zulu time when the program identifies
aircraft movement (from a GPS or the GPS Simulator Trainer) is greater than
the ground speed setting. The ground speed setting can be modified in the
Track/Vertical Profile tab of the FliteDeck Setup program. The local time is
generated from the Time Zone where movement occurred.
• Time On displays the local and Zulu time when the program identifies aircraft
movement (from a GPS or the GPS Simulator Trainer) is less than the ground
speed setting. The ground speed setting can be modified in the Track/Vertical
Profile tab of the FliteDeck Setup program. The local time is generated from
the Time Zone where movement slowed or ceased.
NOTE Time On and Time Off only reset when the program closes.
• Sunrise in Local and GMT displays the local and GMT time of the sunrise. The
sunrise local time is based upon your current position on the moving map
using a GPS or the GPS simulator.
• Sunset in Local and GMT—Displays the local and GMT time of the sunset. The
sunset local time is based upon your current position on the moving map
using a GPS or the GPS simulator.
• Current Time displays the local and Zulu time based upon the time zone of
the airport nearest to your current position. The time is calculated starting
from your computer clock, and adding or subtracting to match the time zone
of your current position. The time zone of your current location displays below
the clock time. If you are more than 150 miles from an airport, the letters of
the alphabet appear indicating military time. For a list of military letter
designations, visit http://wwp.greenwichmeantime.com/info/timezone.htm on
the Internet.
NOTE
The Current Time block does not use the time zone set on your
computer clock. JeppView FliteDeck looks at your current position from
the GPS, and displays the time zone in that location. For example, your
computer clock might be set to Eastern Time, but if you are traveling on
the Pacific Coast, JeppView FliteDeck displays the current time using
Pacific Time.
Block 5 — Route Information
Click this block (or press F5) to cycle between various types of information:
• Route — Leg DTK is the desired track (DTK) to each waypoint in the route
from the previous waypoint. Helps you anticipate turns at upcoming
waypoints.