Jeppesen FliteDeck 3 - Manual (Page 70)

73
FliteDeck Setup
The first time you use FliteDeck, the FliteDeck Setup program leads you through an
interview with questions about your preferred methods of using the program,
computer setup, and GPS hardware.
To open the FliteDeck Setup program, go to Start > Programs > Jeppesen >
JeppView FliteDeck3 > FliteDeck3 Setup.
Use the FliteDeck Setup program to set your preferred options as you run FliteDeck.
Not all options are asked in the Setup Wizard, but it will get FliteDeck working with
your hardware so you can become comfortable with the program.
The Interview
To get started, go all the way through the Interview the first time you run FliteDeck,
answering all questions as best you can. As you gain more understanding about what
options you prefer, you can return to the Setup program and re-run the Interviews,
or you can make changes directly by selecting and clearing options in the Setup
program tabs. If you do not find the option you’re looking for in the Setup program,
click Interview from anywhere in the Setup program; some options can only be
selected in the Interview.
• If you are in the Interview and want to stop, click Cancel. You can then
select options directly.
• When you are done, click OK to apply your selections.
Any changes made within FliteDeck Setup take effect the next time you start
FliteDeck.
Returning to FliteDeck Setup
As you get to know the program better, you can return to the Setup program and
change your settings:
1. Click Start > Programs > Jeppesen > JeppView FliteDeck3 >
FliteDeck3 Setup.
2. When you are done working with the FliteDeck Setup program, click OK.
The FliteDeck Setup program has ten tabs:
IMPORTANT
Configuration and setup should not be done while flying. Any
changes you make in Setup do not take effect until you close and
reopen FliteDeck.