Jeppesen FliteDeck 3 - Manual (Page 201)

JeppView FliteDeck User's Guide
204
If you do not want JWC to initialize XmLink at startup, you can change the start-up
option to a manual setting or disable it completely.
If you changed the startup option of JWC, and you want to place it back into the
automatic startup default setting where it starts every time your computer powers
on:
1. Open the Services Console by using one of the following methods:
o
Click Start > Run, enter services.msc, and then click OK.
o
Click Start > Control Panel > Administrative Tools, and then
double-click Services.
o
Click Start > Control Panel > Performance and Maintenance >
Administrative Tools, and then double-click Services.
2. Right-click Jeppesen Weather Controller Services and choose Properties
from the shortcut menu.
3. In the General tab, select Automatic from the Startup type drop-down list.
4. Click Apply, and then OK.
5. In the Services Console, click File > Close.
Manual Startup
The following method stops JWC from starting when you power on your computer.
However, it will initialize and start XmLink when FliteDeck starts.
To change the JWC startup to manual:
1. Open the Services Console by using one of the following methods:
o
Click Start > Run, and enter services.msc, and then click OK.
o
Click Start > Control Panel > Administrative Tools, and then
double-click Services.
o
Click Start > Control Panel > Performance and Maintenance >
Administrative Tools, and then double-click Services.
2. Right-click Jeppesen Weather Controller Services and choose Properties
from the shortcut menu.
3. In the General tab, select Manual from the Startup type drop-down list.
4. Click Apply, and then OK.
5. Click File > Exit.
When you power on your computer, JWC will no longer initialize XmLink. However,
when you start FliteDeck, JWC will initialize and launch XmLink. If a receiver is not
connected, the
XM2Nr Error dialog box appears. At this time, you have the option to
connect a receiver or dismiss the message.
Use the following method if you are using the manual startup setting, and you want
to start collecting weather data before starting FliteDeck:
1. Connect and power on your weather receiver.