Jeppesen FliteDeck 3 - Manual (Page 34)

Installation and Activation
37
Installing Electronic Chart Data Disc 1
After you have deployed the master image to the workstations, install ECD Disc 1
and 2 on the workstations. To install terminal charts, follow these steps:
1. If the setup program does not start automatically, click Start > Run. Type
d:\setup.exe
(where d: is the letter of the CD-ROM drive).
2. Check for the terminal chart coverages that you have purchased under your
serial number, and click Next.
A. The first time you install the ECD Disc 1 on a given computer, you might not
see any coverages. If that occurs, a box appears near the bottom of the
Setup window for entering a coverage code.
B. Type the coverage codes from the back of your JeppView CD album (below
the Serial Number, 9-12 alphanumeric characters), and then click Apply.
IMPORTANT
Coverage codes change with each terminal chart cycle. If the
coverage code you have no longer works, or you don’t have a
coverage code, or you don’t see the coverages you need after
entering your codes, have your order number or customer
number available and contact Jeppesen Customer Service. After
you have the codes you need, complete the steps outlined
below.
C. If necessary, restart the ECD Disc 1 Setup program.
D. On the Coverages screen, select the I have additional Coverage Codes
check box, and then click Next. Setup displays a box into which you type
additional codes.
E. Type any coverage codes you have, and then click Apply.
3. At the end of the ECD Disc 1 installation, Setup stops and waits for ECD Disc
2. While the Insert Electronic Chart Data Disc 2 dialog box is on the screen:
A. Insert ECD Disc 2 and wait for Setup to continue.
B. Click Close Window if this window does not go away automatically.
C. Continue with Installing the ECD Disc 2.
If you did not receive a serial number or coverage code, please contact Jeppesen
Customer Service . If you need terminal charts outside your current coverage area,
you can expand your coverage immediately by contacting Jeppesen and purchasing
additional coverage codes.
Installing Electronic Chart Data Disc 2