Kontron NSW1U IP Network Server - Manual (Page 26)

NSW1U Network Server—Server Installations and Upgrades
Kontron IP Network Server NSW1U
Product Guide, rev. 1.4 December 2009
26
3.2.2 Installing the Chassis Cover
1. Place the cover over the chassis so that the side edges of the cover sit just inside the chassis
sidewalls, with the front of the cover showing an approximate 1/8-inch (3 mm) gap between the
chassis cover and the sheet-metal at the front of the chassis.
2. Press down slightly on the chassis cover behind the front bezel area and slide the cover forward
until it clicks into place.
3. Install the shipping screw if desired.
4. Reconnect all peripheral devices and the power cord.
Caution: This unit must always be operated with the top cover installed to ensure proper cooling.
3.2.3 Removing the Front Bezel
Remove the front bezel to install or remove an optical device. For the NSW1U-F and NSW1U-B
servers, the front bezel must also be removed to install the optional 4xGbE LAN card.
1. Remove the left-side screw and cable management arm, if installed. ( Figure 13 , “A”).
2. Remove the right-side screw to release the bezel. (“B”)
Note: Hold the bezel in place while you loosen the screws. After both screws are loosened,
the bezel will drop from the chassis.
3. Lift the front bezel from the chassis.
Figure 12. Removing the Chassis Cover
AF000876rev
A
B
C