Kontron NSW1U IP Network Server - Manual (Page 64)

NSW1U Network Server—Optional Component Installation Procedures
Kontron IP Network Server NSW1U
Product Guide, rev. 1.4 December 2009
64
6. Place the PCI fan air duct back into the chassis (“A” in Figure 48 ) and replace the screws that hold
the air duct in place (“B” in Figure 48 ).
7. Plug the other end of the SysCon cable into the connector on the front panel (EFP) board. (“C” in )
8. If this is the last task you are performing, replace the top cover of the chassis. Reconnect all the
external devices and plug in the power cord(s).
Figure 48. Re-Installing the PCI Fan Air Duct with the Solid-State Drive Attached
TS000508
A
B
C