Kontron NSW1U IP Network Server - Manual (Page 48)

NSW1U Network Server—Optional Component Installation Procedures
Kontron IP Network Server NSW1U
Product Guide, rev. 1.4 December 2009
48
4.2.3 Installing the Drive in the Chassis
1. Use the guide pin to insert the drive tray into the front panel. Insert the primary drive in the right
bay.
2. Fasten the front panel screw and rear screw. (“B” and “C”)
3. Attach the combination data/power connector to the back of the drive and plug into the EFP
board. (See Figure 2 for cable routing.)
4. If this is the last task you are performing, replace the front panel, the processor air duct, and the
top cover of the chassis. Reconnect all the external devices and plug in the power cord(s).
Figure 27. Attaching a Hard Disk Drive to a Drive Tray
E
AF000820
D
B
A
C