Kontron NSW1U IP Network Server - Manual (Page 59)

Kontron IP Network Server NSW1U
December 2009 Product Guide, rev. 1.4
59
Optional Component Installation Procedures—NSW1U Network Server
3. Fasten the LAN card bracket with both screws. ( Figure 42 , “A”)
4. Install the riser card assembly back into the server board slot and fasten the thumbscrew. For
instructions, see Section 4.4.4, “Installing the Riser Card Assembly onto the Server Board” on
page 54
5. Guide the cables through the support bracket opening toward the front panel. (“B”).
6. Insert the GbE cable connector from the rear of the front panel into the escutcheon as shown in
Figure 43 .
Figure 41. PCI Support Brackets
Figure 42. LAN Card Cables in Support Bracket
A
B
AF000888
A
B
AF000889