Kontron NSW1U IP Network Server - Manual (Page 40)

NSW1U Network Server—Server Installations and Upgrades
Kontron IP Network Server NSW1U
Product Guide, rev. 1.4 December 2009
40
6. Close the socket lever and ensure that the load plate tab engages under the socket lever when
fully closed. (“B” and “C”)
3.3.4.4 Setting the Processor Select Jumper
The server ships pre-configured for the Dual-Core Intel ® Xeon ® processor 5100 series. To use a
Quad-Core Intel ® Xeon ® processor 5400 series, If you change the type of processor that is installed
you must appropriately configure the processor select jumper.
• For a Dual-Core Intel ® Xeon ® processor 5100 series, make sure the jumper is installed on pins 1-
2 on the processor select jumper.
• For a Quad-Core Intel ® Xeon ® processor 5400 series, remove the jumper.
Caution: Never install the jumper on pins 2-3. Your system will not boot if these pins are
jumpered.
This jumper is located at position J3E2 on the server board. See the following figure.
3.3.4.5 Installing the Heat Sink
1. If this is a new heat sink (not the one you removed above), remove the protective film, if present,
on the Thermal Interface Material (TIM) located on the bottom of the heat sink.
2. Set the heat sink over the processor, lining up the four captive screws with the four posts
surrounding the processor. Align the heat sink fins to the front and back of the chassis for correct
airflow (front to back). Use caution and make sure that cables are not pinched beneath the heat
sink. (See Figure 18 .)
3. Loosely screw in the captive screws on the heat sink corners by tightening one, then the one
diagonally opposite, and so on.
4. Gradually and equally tighten each captive screw in diagonal order until each is firmly tightened.
See Figure 18 for the order.
Caution: The torque spec for these screws is 8 inch-pounds. Be careful not to exceed it.
CPU CPU
J3E2
1 2 3
1 2 3
for Dual-Core Intel ®
Xeon ® Processor
5100 Series:
for Quad-Core Intel ®
Xeon ® Processor
5400 Series:
NO jumper
installed.
Install jumper
over pins 1-2.
CAUTION: Jumper J3E2 must be
configured to match your installed
processor or your system will not boot
properly.
Server
Board