Kontron NSW1U IP Network Server - Manual (Page 56)

NSW1U Network Server—Optional Component Installation Procedures
Kontron IP Network Server NSW1U
Product Guide, rev. 1.4 December 2009
56
4.6 Installing the Quad Port Bypass Server Adapter (Copper)
for Front Panel Access
The NSW1U-F and NSW1U-B IP network servers come with a front panel filler panel that has to be
removed and replaced with an escutcheon when installing a GbE LAN card, such as the Intel ® PRO/
1000 AT Quad Port Bypass Server Adapter for Copper (NIC in front), for the first time. The chassis
cover and the front bezel must be removed to install or replace the LAN card and to connect the GbE
cables to the escutcheon. In addition, a special LAN card support bracket with a cable opening must
be used, replacing the factory-installed support bracket.
4.6.1 Installing the 4xGbE LAN Card
Note: This section details the instructions for installing the card for copper GbE connectors
only.
Figure 37. Installing the Remote Management Module
C
D
GCM3 Module RMM Module
A
B
TS000414