Kontron NSW1U IP Network Server - Manual (Page 52)

NSW1U Network Server—Optional Component Installation Procedures
Kontron IP Network Server NSW1U
Product Guide, rev. 1.4 December 2009
52
4.4.1 Removing the PCI Riser Card Assembly
To remove an installed riser card assembly, follow these steps:
1. Loosen the blue captive screw that secures the riser card assembly to the server board. (“A” in
Figure 32 )
2. Loosen the blue captive thumb screw on the rear panel of the chassis. (“B”)
Caution: Touching the battery with a metallic object, such as any part of the PCI riser assembly,
can momentarily short the battery.
3. Lift the riser card assembly straight up and remove it from the chassis. (“C”)
Figure 32. Removing the Riser Card Assembly
TS000411
A
B
C