Kontron NSW1U IP Network Server - Manual (Page 53)

Kontron IP Network Server NSW1U
December 2009 Product Guide, rev. 1.4
53
Optional Component Installation Procedures—NSW1U Network Server
4.4.2 Removing a PCI card from the Riser Card Assembly
Caution: When handling a PCI card, observe the normal safety and ESD precautions. See
Appendix A, “Safety Information” for more information.
1. Turn the riser card assembly upside-down to remove the PCI card.
2. Remove the rear retention screw from the riser card. (“A” in
Figure 33 )
3. Detach the PCI card from the riser card connector. (“B”)
4.4.3 Installing an Add-In Card in the Riser Card Assembly
Caution: When handling an add-in card, observe the normal safety and ESD precautions. See
Appendix A, “Safety Information” for more information.
The following procedure uses a PCIe card as the example.
1. If the current riser card in the assembly is not correct for the PCI card you are installing, i.e., in
this example, the PCI-X riser card instead of a PCIe riser card, do the following:
a. With the riser card assembly upside-down, remove the riser card by loosening the two screws
that attach it to the riser card assembly sheet metal top.
b. Fasten the new riser card, i.e., the PCIe riser card in this example, using the two screws.
2. If the add-in card slot was empty before installing the new card, remove the filler panel from the
rear bracket.
3. With the riser card assembly upside-down, slide the PCI card onto the sheet metal and attach it to
the riser card connector. (“A” in Figure 34 )
Be sure that the PCI card edge connector is seated in the riser card connector correctly.
4. Fasten the PCI card to the riser card assembly bracket using the retention screw. (“B”)
Figure 33. Removing a PCI-X Card from the Riser Card Assembly
TS000213
A
B