Rice Lake MSI-7300 Dyna-Link 2 - Manual (Page 10)

6 MSI-7300 Operator’s Manual
1.4 MSI-7300 Annunciators
The Dyna-Link 2 uses LCD annunciators to indicate tension mode and other
information.
Figure 1-3. MSI7300 Annunciators
Stable – indicates the tension force has settled within the motion window
(usually ±1d).
When standstill is off, the link will not zero, tare, or totalize.
Center-of-Zero – Indicates the tension is within 1/4 d of zero.
BT Low Battery – Appears when approximately 10% of battery life remains.
The BT symbol blinks when automatic shutdown is imminent.
Pk
PEAK- Indicates peak hold mode.
Ttl TOTAL – Indicates the unit is displaying the total accumulated weight.
This is a temporary display lasting less than five seconds.
Net NET – Indicates the unit is in the net tension mode.
A tare weight is subtracted from the gross tension.
M
Metric Ton – In conjunction with the ton annunciator, indicates the unit is
displaying metric tons.
When used with the total display, it is used for X1000 to allow
accumulation of weight beyond the five digit display capacity.
It is also used with the service counters when the number of lifts exceeds
five digits.
kg
kg – Indicates tension display is in kilograms.
kN
kN – Indicates the tension display is in kilonewtons.
lb
lb – Indicates tension display is in pounds.
Ton
Ton – Illuminated alone, indicates the unit is displaying in US short tons
(1 ton = 2000 lb).
When illuminated along with the ‘M’ the unit is displaying in metric tons
(1 metric ton = 1000 kg)
SETPOINTS – User programmable setpoints for early overload warnings.
Setpoints 1 and 2 are high brightness red LEDs
F1 F2 – These blue LEDs are used to indicate various operational features
of functions programmed into the F1 and F2 keys.
Example: In peak hold mode the associated LED will blink whenever a
new peak reading is captured.
0